![]() ![]() In Virtual AGC Mode Orbiter attitude and engine control is disabled, the spacecraft needs to be controlled like the real one by using the panel, the Rotation Hand Controller (RHC) and the Translation Hand Controller (THC) controlling the PGNCS or SCS. So normally the settings here aren't used in Quickstart Mode, but optionally Orbiter attitude control can be disabled, see next section. While this is unrealistic as no electricity is needed and the thrusters are throttable etc., this is intended for new users to get familiar with the Apollo spacecraft without to have to care about the real spacecraft systems like the RHC, the THC or realistic attitude control. In Quickstart Mode the CSM RCS and the SPS engine are controlled by Orbiter directly as for example in the Delta-glider including the navmodes (killrot etc.), attitude and engine control by MFDs etc. The Controls tab of the Launchpad Options. If you have a powerful graphic adapter you can switch to "smooth scrolling", then the FDAIs are updated every timestep, which should provide a smoother scrolling. To maintain a proper frame rate even with slower graphic adapters the FDAIs are redrawn very carefully. To completely disable the FDAIs in this case, check the "Disabled" check box. That can cause problems or even crashes with some graphic adapters. The FDAI is a kind of "artificial horizon", which is implemented by using the OpenGL interface. The Optics, MFDs, and DSKY will remain in the center panel. This option allows you to split the lower bay panel into three slightly overlapping lower panels. The lower equipment bay panel has evolved to be larger over the course of development. To address this problem or if you just want to have a split main panel instead of scrolling a huge single panel, switch to "Multiple, spit panels". Especially the CSM main panel is very large, which can cause frame rate problems with some graphic adapters. The CSM 2D cockpit features fully functional control panels. This can substantially increase frame-rates on slow machines. Setting to "Low resolution" will switch to low resolution Saturn IB and Saturn V meshes. The Visuals tab of the Launchpad Options. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |